DSP Waveform Generator ( DWG100 )

The correct appearance of this website is only visible in graphical browsers that support web standards. We try to ensure our content is accessible to any browser but we recommend you upgrade your web browser if you can.

DSP Waveform Generator

Product Summary
Order Code	ADD TO CART DWG100
Description	BitGen integrated waveform and timing generator solution for USB BitScope 100. Pre-installed if purchased with BS100U.
Comment	Option for BS100.
Price	USD (US Dollar) $ 64.95
Net Weight	20 g

Product Information

DWG100 is a DSP based waveform and timing generator upgrade for USB BitScope 100.

It mounts inside the BitScope and comes with installation instructions and new software.

Note: DWG100 and the required software is pre-installed when purchased with new BS100U.

Waveform Generators	Specification
Generator Types [1]	VSR, DDS, CLK & PRNG
Frequency (max) [2]	1MHz (DDS, PRNG), 1.5MHz (VSR) or 5MHz (CLK)
Frequency (min) [2]	1mHz (DDS), 1Hz (VSR, PRNG) or 1kHz (CLK)
Resolution	6 digits or 1mHz (DDS)
Accuracy [3]	±30ppm, 18° to 30° (typical)
Temperature Coefficient [4]	≈1ppm/°C
Built-in Wave-Functions	Sine, Ramp, Step, Exponential, Noise
Loadable Wavetable Size	2 to 1024 samples
Trigger/Burst/Clock [5]	Specification
Operating Modes	Burst, Gated, Sweep, Clock In/Out
Burst Duration [6]	1uS to >1Hr
Post-Trigger Delay [6]	500nS to >1Hr
Inter-burst Delay [6]	500nS to >1Hr
Burst Repeat Count	2^32 (max)
WavePort	Specification
Output Level	10Vpp to 40mVpp
Output Offset	±2.5Vpp
Output Impedance	50Ω
Output Voltage Tolerance	±12V (max)
Waveform Resolution (D/A)	8 bits (multiplying)
TimePort	Specification
Output Type	3-state, 100k to GND
Logic Levels	5V CMOS In/Out
Output Drive	Active (low ≈0.6V, high ≈4.4V)
Output Impedance	100Ω (50mA max)
Trigger Latency	200nS (typical)
External Clock (max)	2MHz
Minimum Pulse Width	100nS

[1]	Supports 4 different generator types: VSR = Variable Sample Rate, DDS = Direct Digital Synthesis, CLK = Clock Generator, PRNG = Psuedo Random Number Generator.
[2]	Minimum and maximum frequency depends on generator type as indicated.
[3]	Uncalibrated frequency accuracy is specified (as defined by the BS100U reference crystal). May be calibrated to better than this if precision frequency reference is available.
[4]	Temperature Coefficient is that of the BS100U reference crystal.
[5]	Trigger, Burst and Clock modes may be configured to accept or generate a trigger or clock signal via the TimePort.
[6]	The maximum duration or delay depends on the sample rate. The maximum duration in all cases exceeds 1 hour but can extend far beyond this limit at lower sample rates.

E&OE